Another situation
of water ring vacuum pump is analyzed. Maybe it's the first time to hear the
word about the problem of holding shaft. At first, I don't understand what it
means. Is the vacuum pump not working? There are many reasons for this
phenomenon. The following is a systematic analysis of the reasons for this
situation, which may be helpful for future use.
The problem of water ring
vacuum pump shaft holding mainly starts from the bearing components. The
specific reasons are as follows: there are differences in the quality of the
bearing itself, or the wear and aging caused by long-time operation. In the
assembly process, there is a big gap between the positioning and design
requirements of the bearing, the positioning is not accurate, the selection of
each component is unreasonable, and the quality of lubricating oil is also
related to this situation, If the overall vibration of the pump is too large, it
is also caused by this reason.
The various reasons described above are the
problems that lead to the phenomenon of water ring vacuum pump holding shaft.
The user can judge which component is responsible according to these conditions,
so that remedial measures can be made in a short time without hindering the
normal production operation. If you still don't understand this aspect, you can
contact our company's after-sales department in time for guidance, Thank you for
choosing our products.
Related products:
No comments:
Post a Comment